A multi-layer system applied to the outside of a wall to insulate it continuously, eliminating thermal bridges. The insulation board is bonded (and often anchored) to the substrate, then covered with a reinforced base coat and a finishing render.
Technical section of the system, from inside (left) to outside (right).
A multi-layer system applied to the outside of a wall to insulate it continuously, eliminating thermal bridges. The insulation board is bonded (and often anchored) to the substrate, then covered with a reinforced base coat and a finishing render.
ETICS (External Thermal Insulation Composite System) marks the shift of the building envelope from a single-material logic to a composite organism. Governed by the European Assessment Document (EAD 040083-00-0404, the evolution of ETAG 004), external insulation stops being a mere stack of site materials and becomes an inseparable «kit», designed to cancel structural thermal bridges and protect the building's thermal mass.
The thermodynamic, hygrometric and fire performance of external insulation depends entirely on using the components specified by the system manufacturer together. EAD 040083-00-0404 requires a European Technical Assessment (ETA) covering the kit as a whole. Changing even a single component — for instance swapping the alkali-resistant glass-fibre mesh, or using an adhesive not tested for that specific board (EPS, rock wool or wood fibre) — immediately voids the CE marking, exposing the system to premature detachment and nullifying insurance cover and tax incentives.
The Italian UNI/TR 11715 practice prescribes the construction details. The insulation board must be bonded over its whole surface (on planar substrates) or with a perimeter bead and central dabs. The sealed perimeter bead is essential: it prevents interconnected air gaps between boards that would trigger convective motions (chimney effect), degrading thermal efficiency and helping flames spread in a fire. The mechanical core of ETICS, however, is the reinforced base coat: embedding the mesh in the outer third of the base coat creates an elastic armour that absorbs hygrometric shrinkage and the micro-movements caused by daily thermal swings, which on dark façades can exceed 70 °C under summer sun.
The thick finishing coat, usually based on acrylic-siloxane resins or silicates, must solve a building-physics paradox: repelling rainwater (driving rain) while keeping high vapour permeability (μ). By Glaser's principle, the vapour-diffusion resistance of the whole build-up must decrease from inside to outside. If the outer finish were vapour-tight, moisture generated indoors would condense within the insulation or behind the base coat, causing swelling, frost damage and system detachment (blistering). For the same reason the finishes' light reflectance value (LRV) should stay above 20%, to avoid thermal shocks that damage the polystyrene beneath.
By moving the insulation outside, the masonry stays close to the indoor temperature: the dew point falls within the insulation (or the base coat), not in the structure. The result: no thermal bridge and no interstitial condensation in the wall.
The most exposed point to water and impact: starter profile with a drip edge, a low-absorption XPS band straddling ground level, detachment from the soil.
Cuts the thermal bridge of the opening: insulation returns into the reveal up to the frame, with an expanding sealing tape and a reinforced corner bead.
At structural joints the ETICS is interrupted with a bellows profile that follows the movements without cracking the base coat.
Informational links to the regulatory framework. Always verify the current text on the official source.
A ready-to-edit DOCX from this system’s data — build-up, performance, and cited regulations with their current in-force status. Courtesy draft, free.